Bryant Grinder LL1 Workhead Spindle

Description

This work spindle came off a Bryant Grinder LL1 ID grinder.  It is a four bearing, high precision spindle.  When new, it was spec'd to have 0.000005" Run Out.  Machine was grinding fuel injector seats.  It is a through spindle.
Front spindle nose is 6.000" OD.
Front spindle nose inner seal diameter is 2.025" (measured on rubber seal)
Through hole max ID is roughly 1.2", hard to measure as the min ID is in the middle of the spindle.
Rear through hole is 3.060" OD, 1.945" ID.
Dovetail foot mount is 7-7/8" wide, 6-1/8" long.  Pads are about 2" wide each side.
Body width is 7"
Body height is 8"
Total length is 9-7/8"
Spindle nose projects out 2.560" from the body.
Let me know if you require additional dimensions.
A wooden box will be constructed for shipment.